Odd brass bushing from cyl head? - Maintenance and Repair Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Odd brass bushing from cyl head?
Wednesday, June 13, 2018 6:43 PM
My first time rebuilding a 2.2 Ecotec cylinder head. I was stripping it on a clean bench and found this brass bushing laying on the bench! It's not a valve guide or aligning dowel.

I cannot figure out where it came from. Any help would be greatly appreciated.

John
Attachments
bush3.jpg (716k)
bush2.jpg (639k)
bush1.jpg (309k)


Re: Odd brass bushing from cyl head?
Monday, June 18, 2018 9:22 AM
No one else has responded, so I'll go ahead and say that I don't think that came out of an l61 head.



"In Oldskool we trust"
Re: Odd brass bushing from cyl head?
Friday, June 22, 2018 5:45 AM
Pretty sure they are no from an ecotec. I stripped a few completly down and haven't found any.




On the inside my car looks like a fighter jet.
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search