Torque converter or engine? - Maintenance and Repair Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Torque converter or engine?
Tuesday, September 03, 2019 3:23 PM
So, I have a few symptoms and searching hasn't really yeilded any useful answers.

The symptoms

1.) Occasional power outage with no discernible cause - battery, alternator, starter all check out. One ground wire is a bit rusty but even so everything's getting sufficient flow. When this occurs it acts like it has a dead battery. I've noticed my key upon exiting the ignition is warm to the touch.

2.) Once in a blue moon, most noticeable during hot weather or high eng temperatures, the car upon acceleration lags. It's as if it doesn't want to move under it's own weight. It loses all power and moves at a snails pace. I can press on the pedal all I want and it struggles to move. Yet, no codes are present other than a P0507(not during the lack of power/moving under own weight occurrence). No odd smells. No whining, rattling, grinding or any strange noises at all. Oil fluid is in operating range. Trans fluid seems okay. Fuel filter is new.

I'm not really sure what to look for to address this out of nowhere power loss. I'm thinking it's transmission related but, again, nothing seems out of the ordinary.

It's a 96 cavalier with the 3spd

Re: Torque converter or engine?
Wednesday, September 04, 2019 5:26 AM
Check and clean all of the grounds. Even a little @!#$y on ground can cause big issues.




Re: Torque converter or engine?
Wednesday, September 04, 2019 9:42 PM
I know the overdrive solenoid can cause it to bog and stall, more so when its hot but if its bad enough itll run rough right from the start. Tps can also cause this


ReD RaiN
Re: Torque converter or engine?
Thursday, September 05, 2019 2:39 AM
Overdrive solenoid? Where would that be located?
Re: Torque converter or engine?
Thursday, September 05, 2019 2:10 PM
I don't think it is the Torque Converter Clutch Solenoid. When those fail, the engine will stall when coming to a stop. Just like a manual shift would do if you didn't push in the clutch when stopping in gear.
Re: Torque converter or engine?
Friday, September 06, 2019 5:30 AM
Here's an update - Went to start the car and the sane no power situation occured. I got the idea to hit the underside of the steering wheel near the ignition cylinder and boom, power flickered and I managed to start the car.

Sooo, turns it out might be wiring or the ignition cylinder itself. What exactly should I be on tbe lookout for aside from burnt/bad wiring? Are there any signs specific to tell a bad ignition cylinder or is it just one of those things where your only option is to replace it and hope for the best?
Re: Torque converter or engine?
Friday, September 06, 2019 8:53 PM
T!M8!T wrote:

I know the overdrive solenoid can cause it to bog and stall, more so when its hot but if its bad enough itll run rough right from the start. Tps can also cause this

Tbh im not sure whether these cars have a overdrive solenoid. My old 91 cav had one but im not sure with these. Someone else may be able to pitch in.


ReD RaiN
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search