Yea I know this should go into the wanted ads section but I need asap and prefer local pickup. I am looking for the ecotec wiring harness for an auto transmission. I put an autotrans interceptor in and decided not to keep it. I *soldered* (spell check) the wires back together but I am still getting the hard shifts and the trans is making some noise even in park. I was told that the problem is that the soldering is causing a different reading to the transmission hence the hard shifts. Anyone have any ideas or a wiring harness let me know.
dude, there is no way you would need an entire wiring harness
should be a very simple fix
Just run a whole new wire from a to b where it its needed. If you need help, you have my phone #.
the solder shouldn't cause enough resistance to throw what the trans is reading off... something else is messed up.
“When you come across a big kettle of crazy, it’s best not to stir it.”
Naw man I need your number again. Got like 3 new cell phones since then.
P.S. I already tried the new wire thing but it was a little bigger gauge than the factory. I thought it was causing the lower resistance thing also.