Almost a year and still not finished. I installed the short block and then dropped the head off for machining. I found a nos cam kit. Well the head is cracked. Does anyone know of a really good shop that knows how to repair these the right way. Because if I don't get it done I have to use a 2.0 head from the 91 that means machining the combustion chamber. Any help would be greatly appreciated
Why would you need to machine the combustion chamber? I don't know of any changes in the combustion chamber on any of the engines in these cars (for same head design to same head design that is)
The chamber is different between the turbo and the Nat asp heads higher compression
Not sure where you are located, but the machine shop
should know a good aluminum welder.
The ones around here do.
If the crack is in the chamber you will compromise the
valve seats from the welding heat and have to heve
those redone also.
Honestly , starting with a non turbo less stressed
head might be the better route anyway.
Die grinding 4 chambers isnt that difficult.
Harbor freight diegrinder and a rotary burr.
Then cc them true.
A good machine shop should be able to fix the cracks. I had three done recently at a shop here in the Northeast, a 1.8 and two 2.0 heads all with the typical between-the-seats cracks. Also watch out that they don't get decked too far. It affects cam timing with a SOHC; and of course compression.
There were a few different combustion chamber designs for the 2.0L but I believe the 1.8s were all the same. Also if you're going to swap to a 2.0 head, you will need a different intake.
86 Skyhawk wagon 1.8SOHC • 93 Sunbird two door 2.0SOHC • 93 Sunbird four door 2.0SOHC
Both heads have cracks so I'm going to fix the original. I have talked to ARP about head studs they need measurements of the bolt holes etc. Also commetic gaskets have a mls for these. If I had to do this over I'd just look to Europe for parts. But I'm on a f***ing quest now. This car is in too good of shape not to finish it
So I have some time to work on it. I have to put the oil pressure sending unit in. The adapter breaks off in the oil pump. Have to remove pump. Just trying to get this ready for the head.2 steps forward 3 steps back