tein pillowball on kw coilovers? - Suspension and Brake Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
tein pillowball on kw coilovers?
Sunday, February 07, 2016 5:02 PM
Like the title says. Can I use tein pillowball mounts on my kw v1 coilovers?

Re: tein pillowball on kw coilovers?
Sunday, February 14, 2016 9:18 AM
Anybody?
Re: tein pillowball on kw coilovers?
Sunday, February 14, 2016 12:59 PM
I may be possible. You'd have to measure the shaft diameter of the kW vs the tein. I could probably grab a measurement off the teins on my car when I get home tomorrow.

Keep in mind too that the tein mounts are cupped to accommodate the edfc stepper motors so they may not allow you to lower as much as a stock mount (which may or may not matter depending one what you are doing with the car)



Re: tein pillowball on kw coilovers?
Friday, March 04, 2016 5:44 PM
I've been riding on new oem strut mounts and they moan and groan and make terrible noises. I'm only lowered about an inch and a half ( two fingers between tire and wheel well). I just want the sounds gone. This is my daily but I don't mind stiffness as I'm all poly everything. Just want the sound gone
Re: tein pillowball on kw coilovers?
Sunday, December 18, 2016 6:11 PM
I recently acquired a set of kw v1s for next to nothing from someone.. what do I need to mount them to the car? Just mounting plates or do I need bushings as well? Wanna order all new so I can pull old junk struts out n be ready to put kws in
Thanks in advance
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search