bushings - Third Generation Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
bushings
Wednesday, July 06, 2005 9:39 PM
well i'm almost done with my motor swap and i've noticed i need tierod end bushings. where can iget those? preferably urethane.

Re: bushings
Wednesday, July 06, 2005 10:34 PM
all i can find are tie rod end boots which i assume are for the inner tie rods
Re: bushings
Sunday, July 17, 2005 8:47 PM
Where do these go to that you need?



www.kronosperformance.com / 732-742-8837

Re: bushings
Sunday, July 17, 2005 9:28 PM
Well there isn't such thing as tie-rod end bushings, unless you are talking about the boot. The boot is what keeps the grease inside the tie-rod end and keeps crap from getting in. The only bushing for J-bodies on the rack, are for the inner tie-rods. And even then the inner tie-rod bushings are only for 2nd gens..the 3rd gens have a different setup
Re: bushings
Sunday, July 17, 2005 9:57 PM
well, it is full of grease but it seemed more like a bushing than a boot. so are there any urethane "boots?"
Re: bushings
Monday, July 18, 2005 6:49 AM
Yah I've seen them before...I think Prothane makes a set
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search