3.1 v6 tranny on a 2.3 quad - Transmission Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
3.1 v6 tranny on a 2.3 quad
Sunday, July 08, 2012 6:16 PM
I heard the bell housing on the tranny for 2.3 quad 4 was the same as a v6. Does any body know if a 2.3 will bolt up to a tranny out of a 3.1 car?

Re: 3.1 v6 tranny on a 2.3 quad
Sunday, July 08, 2012 6:27 PM
No, the bell housing for the 2.3 is the same as the 2.4.

A 3.1 ohv shares a bell housing pattern with the 2.2 ohv (aka non-eco) which is different than the 2.3/2.4









Re: 3.1 v6 tranny on a 2.3 quad
Monday, July 09, 2012 5:52 AM
Teh n3wb^^ is correct. Use a 2.2 LN2 tranny.

Hi Rob! LOL



Re: 3.1 v6 tranny on a 2.3 quad
Monday, July 09, 2012 5:45 PM
idk where or who told you that but they were high on glue. the quad pattern is a bastard child... sharing it with absolutely nothing else.



I choose the technology built for land speed records... not the technology built to save on emissions and gas mileage.
Re: 3.1 v6 tranny on a 2.3 quad
Monday, July 09, 2012 8:56 PM
Scorpio1 bishes... wrote:Teh n3wb^^ is correct. Use a 2.2 LN2 tranny.

Hi Rob! LOL


No, ur a newb, lol

BTW, hi James!









Re: 3.1 v6 tranny on a 2.3 quad
Monday, August 13, 2012 8:03 PM
Although the bolt pattern is not the same, the older Muncie 282 was used behind both the Quad 4 and the 2.8/3.1 with different gearsets. It is possible to swap the bellhousing over and get a different FD ratio. This may be where the confusion was.
.



Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search