Reflash + Emanage Questions - Page 2 - Tuning Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Re: Reflash + Emanage Questions
Thursday, July 21, 2005 11:40 AM
i don't have a 2nd o2, i unpluged the first one to get it to run...




Re: Reflash + Emanage Questions
Saturday, July 23, 2005 6:20 PM
hey Derek u have msn or an email i can contact you at...as a matter of fact im Derek 2 hahahha
wat a trip
anyways, so u took out all ur 02 sensors and the car runs way better?

<a href="www.daptronics.com">www.daptronics.com Huge Discounts on Electronics</a>
Re: Reflash + Emanage Questions
Saturday, July 23, 2005 8:42 PM
MSN: derek_kosloski@hotmail.com

ya my car will run until the car warms up and then starts stallin if the first o2 is plugged in, runs awsome without it, no idea why...



Re: Reflash + Emanage Questions
Saturday, July 23, 2005 9:21 PM
why are you using the msd also? doesn't the reflash pull timing for you . I am going the same route as you derek. I have ford green tops also. And I am automatic too. Hope you get it worked out because I am going to have emanage, reflash, and 440s also.


<img src="http://img.photobucket.com/albums/v292/dragmyz24/shoppedcav2.jpg">
Rush Racing http://www.gettherush.com/
Re: Reflash + Emanage Questions
Sunday, July 24, 2005 12:04 AM
ya the reflash pulls timing, im not using the msd to control that its simply there for the extra spark, and i have the ignition harness for the emanage, im actualy adding some extra timing in lower rpms with it



Re: Reflash + Emanage Questions
Sunday, July 24, 2005 12:04 AM
msd is pretty much just for stronger spark. all timing is controlled by the reflash (except i advanced it a bit with the emanage ), and the emanage is only pulling fuel, and stopping the car from stalling. still no clue why it runs so good without the o2 hooked up.
Re: Reflash + Emanage Questions
Sunday, July 24, 2005 9:11 PM
first off, could i see someones Ignition TIMING map from their setup just so i can get a clue as to whats going on
i took off my o2 sensor, and i RUN PIG rich like in 10's so i quicky go into my ap map, and minus fuel, i see it doesnt even work at alll, i put it all the way to minus 50 at idle and it didnt move...i duno what to do anymore i cant fix this stalling problem

<a href="www.daptronics.com">www.daptronics.com Huge Discounts on Electronics</a>
Re: Reflash + Emanage Questions
Sunday, July 24, 2005 9:46 PM
my car runs maddd rich with the o2 out and it pisses me off , if i jus had it to run 14.7 at idle and @!#$ everything else could get fixed wit it....i wonder why my emanage isnt minusing fuel, especialy when the voltage is at like .7 and still not minusing fuel

<a href="www.daptronics.com">www.daptronics.com Huge Discounts on Electronics</a>
Re: Reflash + Emanage Questions
Sunday, July 24, 2005 11:39 PM
what do you have your injector correction set at? im using that to pull a bunch of fuel, and, fine tune it in the injection map. im running low 11's to high 10's a/f at idle but under part - full throtle its in the high 11's witch seems to be working realy good. my car was also stalling at idle but i havn't had a problem since setting the anti-stall settings like this:

Trottle position: 2%
RPM : 150, 200, 250, 300, 350, 400, 450, 500
Clamp: 2, 1.9, 1.8, 1.7, 1.5, 1.3, 1.1, 1

as i said, i have left my o2 unpluged simply because i cant get the car to run with it, as soon as i plug in the o2 the car stalls. and with my above settings and the 02 unpluged i havn't had any problems and the car has been running great



Re: Reflash + Emanage Questions
Wednesday, July 27, 2005 7:24 AM
damn man dont you go through gas like CRAZYYY haha
wow
at idle u must me flowing crazy amounts of fuel aha anyways ima try this out tonite
i had to cancel my damn dyno appointment cause of this @!#$
owell, off to the car to try sum stuff

<a href="www.daptronics.com">www.daptronics.com Huge Discounts on Electronics</a>
Re: Reflash + Emanage Questions
Wednesday, July 27, 2005 10:11 AM
hey derek thanx alot man, it runs WAYYYYYYYYYYYY better now omg
haha 20 times better
just hard to increase fuel enough on top end once u start gettin into a lower ratio ey haha
owelll ill live
i missed my dyno time this morning so ill post next week for you guys, my tranny is barely holdin up at 8psi,

<a href="www.daptronics.com">www.daptronics.com Huge Discounts on Electronics</a>

Re: Reflash + Emanage Questions
Wednesday, July 27, 2005 12:19 PM
well its not the best on gas, but when driving it im never easy on it so what can i expect lol
glad to hear you got it running good now, let us know how you do once you get it dyno'd!!
do you have a b&m or autotrans interceptor on your car? i would definatly suggest the interceptor, i had the b&m and my trany still slipped under boost, but it doesn't now that i got the interceptor



Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search