AEM afr is off?? - Page 2 - Tuning Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Re: AEM afr is off??
Monday, November 29, 2010 12:23 PM
Added PDF that Ryan posted.
Parts 1 & 2
Attachments
HpTuners_wideband_Setup1.pdf (386k)
HpTuners_wideband_Setup2.pdf (477k)


PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO

Re: AEM afr is off??
Monday, November 29, 2010 12:23 PM
Added PDF that Ryan posted.
Parts 3 & 4
Attachments
HpTuners_wideband_Setup3.pdf (364k)
HpTuners_wideband_Setup4.pdf (341k)


PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
Re: AEM afr is off??
Monday, November 29, 2010 3:07 PM
i wasnt able to do it, i might break out the work light tonight a little later though but i remember that when i was just installing the gauge before and made sure it powered up it held 14.7. i will hopefully be able to confirm tonight


running rich? turn the boost up
Re: AEM afr is off??
Tuesday, November 30, 2010 12:48 PM
Just wanted to say thanks for that Voltage Offset guide.

I've had nothing put problems with my LC-1, I tired to fix it before with some other instructions I found online and it didn't work.

I haven't been able to use the histograms because of this, I've been doing it by trial and error, which I don't have to tell anyone is a major pain in the ass....thank the lord I'm All-Motor so it didn't take long to tune in.

So I will try this in the spring...thanks alot guys!





Re: AEM afr is off??
Tuesday, November 30, 2010 1:36 PM
-MD- Enforcer wrote:Added PDF that Ryan posted.
Parts 1 & 2


thanks for the link!


running rich? turn the boost up
Re: AEM afr is off??
Thursday, December 02, 2010 4:03 AM
with the sensor unplugged, the wideband reads steady 14.8


running rich? turn the boost up
Re: AEM afr is off??
Wednesday, February 16, 2011 5:55 PM
Thanks for the link Ryan, the worksheet there helped me dial in the last little bit for my voltage offset, i have them matching to .1 now. that worksheet showed me how easy it is to do.



Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search