one question? how did you get enough room to remove the multi function switch connector? my hands are too big to fit under to push the tab down to remove it.

thanks

4drcav wrote:

one question? how did you get enough room to remove the multi function switch connector? my hands are too big to fit under to push the tab down to remove it.

thanks

If you're talking about what I think you're talking about,
I just removed the multifunction switch on the steering column to get at the connector.. The screw by the tilt lever is a Pita, but I just used a needle nose to get at it.
Remember, if it can be put together, it can be taken apart.
Good luck!


Matt

I've got an 03+ and did not have to ground the wire in the steering column. Everything worked fine. Not sure if there is a wiring difference on the 03+s because of the different tail wiring.



http://www.cardomain.com/ride/676422/1

you dont even need to remove it... just cut the white wire with some pliers.

http://www.members.shaw.ca/toyota_cavalier/page5/page5.html

I do believe that Lenko did this write up. Its been around for a while. I used it on both of my cars when I did them.


"I would totally eat a marshmallow fairy." - Pintsize

mitdr774 wrote:

http://www.members.shaw.ca/toyota_cavalier/page5/page5.html

I do believe that Lenko did this write up. Its been around for a while. I used it on both of my cars when I did them.

^^^ link is on OP at the bottom for reference along with 2 others.




Matt

Finished installing my toyo tails today and here are the results:

Pic:




Video:

WOO!
Congrats on the install.... bear mits and all!


Matt

^^^^

thanks, the install was actually a lot easier than I made it out to be. but thats what the whole learning experience is all about.


I still say sticky this thread, was a lot of help to me.