What is the best way to take the lens off of the 2001 cavalier headlight? ive heard you need to put it in the over ive also heard to just take a razor to it.
Are you serious?! There's a sticky for this...
________________________________________.
Still not low enough for a signature.
yeah i am so answer or keep the ass to yourself
put it in the oven at 400 degrees for 10-15 minutes. don't worry the lense can take it.
Or you could open your eyes and look at the top of the exterior forum. you know right where you started a new post and read the sticky.
American Henchman wrote:never mind i figured you were to blind to search. well looky here
lol your so funny dude get a life if you read i was not just looking for one way to do it but i guess your just too smart listen lets keep all the bs out and just help each other out with any information we can give with out being douchbags
I just did my 03-05 headlights for a retrofit. I preheated the oven to 175 (f) put the lights in for 10 minutes, when I pulled them out, using a olfa knife ( razor ) and cut the glue and started pulling them apart, if they don't come apart right away, put them back in for 10 minutes and do it again took me about half hour to do both
Skr8 Goodz in tha hood
Cavalier Thompson wrote:I just did my 03-05 headlights for a retrofit. I preheated the oven to 175 (f) put the lights in for 10 minutes, when I pulled them out, using a olfa knife ( razor ) and cut the glue and started pulling them apart, if they don't come apart right away, put them back in for 10 minutes and do it again took me about half hour to do both
thanks for your information and thanks for being help.
No prob bruh, wish it was this simple all the time but it is what it is, take the good wit tha bad on here lol
Skr8 Goodz in tha hood
you dont need an oven for 2000-2002 headlights. just a really sharp blade.
You could also use a cold chisel and a club hammer. Put the chisel up to the seam, then POW!
I have seen people do it very carefully with a dremel, but i think that it would be taking to much of risk.
Exact-o knife is the only tool you need....
Would it kill you to actually SEARCH before asking?
________________________________________.
Still not low enough for a signature.
