4T40E Performance rebuild using IPT parts - Page 4 - Transmission Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Re: 4T40E Performance rebuild using IPT parts
Thursday, September 30, 2010 10:51 AM
Part 2
custom order high stall!
I hate the 500k cap!

Attachments
High Stall Catalog 4t40epart2.pdf (167k)


PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO

Re: 4T40E Performance rebuild using IPT parts
Thursday, September 30, 2010 10:52 AM
I'll upload the rest when I get time!

Yes you are all welcome!




Edited 1 time(s). Last edited Thursday, September 30, 2010 10:52 AM

PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
Re: 4T40E Performance rebuild using IPT parts
Thursday, September 30, 2010 1:06 PM
Question. Would purchasing of the the IPT rebuild kit mean that if you had considered buying the Raybestos clutch pack a thought of the past?



Re: 4T40E Performance rebuild using IPT parts
Thursday, September 30, 2010 1:27 PM
In my opinion the Raybestos clutch pack is the best clutch pack you can buy, but I haven't experienced the ITP parts yet.




PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
Re: 4T40E Performance rebuild using IPT parts
Thursday, September 30, 2010 1:54 PM
I've looked for the price everywhere, what is the average going cost for it?



Re: 4T40E Performance rebuild using IPT parts
Tuesday, May 01, 2012 11:44 AM
Found so more info in one of my old hard drives.


Attachments
100_4498.jpg (30k)
100_4499.jpg (34k)
100_4500.jpg (32k)


PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
Re: 4T40E Performance rebuild using IPT parts
Tuesday, July 10, 2012 8:15 AM
Some more info...
This is the solenoids used for 1st to 4th gear in almost every GM four speed.

1st gear - on - on
2nd gear - off - on
3rd gear - off - off
4th gear - on - off




PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
Re: 4T40E Performance rebuild using IPT parts
Thursday, May 29, 2014 1:16 PM
Just adding more info to this post for future people from HPTuners.








PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search