Cavalier Quarter Panels - Exterior Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Cavalier Quarter Panels
Wednesday, April 03, 2013 5:38 PM
Hello I have a 1998 cavalier sedan and have a losing battle with rust on my quarter panels is it possible to grab a new quarter panel from a newer gen cavalier and put it on or is the size and bolt pattern different?

Re: Cavalier Quarter Panels
Wednesday, April 03, 2013 9:24 PM
All 95-05 sedan quarter pa els are the same whether its a cavalier or sunfire. But its not just a matter of bolt on and go. There will be a lot of cutting, welding, and bodywork to do




Currently #4 in Ecotec Forced Induction horsepower ratings. 505.8 WHP 414WTQ!!!
Currently 3rd quickest Ecotec on the .org - 10.949 @ 131.50 MPH!!!

Re: Cavalier Quarter Panels
Wednesday, April 03, 2013 9:49 PM
where is your rust showing jacob?




Re: Cavalier Quarter Panels
Wednesday, April 03, 2013 9:58 PM
I will get images of the rust tomorrow due to the fact it's night I cannot take them now
Re: Cavalier Quarter Panels
Thursday, April 04, 2013 4:28 PM
Here is the damage on my Quarter Panels


This is Drivers Side had repaired it then a stupid person ended up hitting my car and taking off leaving her like this


Here is my Passangers side where the main part of the cancer is
Re: Cavalier Quarter Panels
Friday, April 05, 2013 6:50 PM
mine's starting to look like that too.... Its depressing.




Re: Cavalier Quarter Panels
Saturday, April 06, 2013 12:58 AM
mine looks way worse.






Re: Cavalier Quarter Panels
Saturday, April 06, 2013 1:00 AM
Mine is just a years worth of rust I did the body work last year
Re: Cavalier Quarter Panels
Saturday, April 06, 2013 10:23 PM
bondo said i can put some fiberglass on my rust and sand it down but body shops say I need a whole new quarter panel.




Re: Cavalier Quarter Panels
Tuesday, April 09, 2013 12:26 AM
I have tried repairing it so I have been thinking of either replacing it or cutting it out and shaping new metal in
Re: Cavalier Quarter Panels
Tuesday, April 09, 2013 6:18 PM
i saw a person on here fix that area by cutting and then welding metal back in and he did a very good job. I Would love to do that but I dont know how to weld that good.





Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search