13/32 or 10.5mm or Letter size Z. Tap size 12 x 1.25.
"The FACTS are always subject to CHANGE once the TRUTH is applied"
"In the entire history of man the only stupid questions are the ones that don't get asked"
On behave of Nick I say thank you
now how hard is it to drill and tap a new hole on the block? and should i just drill and tap it where the old one is? are there special types of drill bits needed to drill into it?
Adam Schneider wrote:now how hard is it to drill and tap a new hole on the block? and should i just drill and tap it where the old one is? are there special types of drill bits needed to drill into it?
Yes drill and tap the old hole. Also since the dipstick tube will be in the way, you need to cover the hole where it goes to make sure no shavings get in the oil pan.
FU Tuning
thanks man that sounds easy enough. i have the sizes for the drill bit and tap but im not sure if i need some kind of special bit and tap or if i can just use a regular metal cutting bit and a tap? does anyone know for sure?
