hey, alright, i posted a thread a little while ago discussing a build on my 2.4L. After looking everything up and talkin with a couple people i think i got a final setup. I already have a couple mods on my car now but ill just give what the final product will be when finished, let me know what ya think.
block bored .020 over
forged 10.5-1 Wiseco Pistons
stainless valves
Eagle Rods
Port and Polished head
Secret Cams
Fuel Pressure Regulator
56mm TB
TB Spacer
Short Ram Intake
4-1 Header
Hi-Flow Catalytic Converter
2.25" custom exhaust
Borla Turbo Muffler
Underdrive Pulley
APEXi SAFC Neo
Clevite Main Bearings
Clivite Rod Bearings
B&M shift plus
Alright, theres the whole build on the LD9, im about 90% sure thats how im gunna run. Anyone whos gone through building one of these before im sure knows how u go round and round until u finally decide on everything. Id like some feedback on this though, if theres anything im missing or anything that you would do otherwise please advise. Im open to any and all suggestions.
http://registry.gmenthusiast.com/images/bruski/thumbnail_personal_pic.jpg
iam also building a 2.4l ld9
heres the build list from my reg should be up and running in about 2 months hopfully
Custom Cold Air Intake with K&N Filter Made By Me
Turbo Tech Solid Trans Mounts
Car Customs Upper & Lower Motor Mounts
Bill's & Stan's Header Ceramic Coated
2.3l Quad 56mm T/B
Ported HOIntake Manifold Ported SandBlasted By Me
Ford Brown Top Injectors
Custom Down Pipe Made by me 2.5"
2.5" Custom Exhaust Made By Me
Manifold Adaptor Plate Ported To Match Head
Stage 2 JBP LD9 Cams
Ported & Polished 2.4l Cyl Head Ported By Me
Stainless Steel Polished Valves Stock sized
HO Valve Springs
HO Valve Retainers
2.4l LD9 Keepers
Felpro Head Gasket Set
Blocks Oil Passages Bored
Cyl Bored .020 Over
Wiseco 10.5:1 Comp Pistons
Eagle H Beam Rods
2.3l Oil Pump Conv
Knife Edged 2.4l Crank
Modded 2.4l Oil Pan Built By Me
Lightened Crank Pulley
Lightened Fidanza 8lb Flywheel
Stage 3 Clutch & Pressure Plate
Team Green Lsd Insert
ARP Main Studs
Balanced Rotating Assembly
HPtuner.
its close to what your is maybe you can get some ideas off my build list.
Paul
