hey again howhard would it be to instal the aluminum crank pulley on my car and what tools would i need to do it thanks
Pretty easy. Just need to loosen the serpentine belt, and remove the plastic fender well. Also a pulley puller is normally required. It is really not that hard to do.
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
directions
judge for yourself
Im a Xbox 360 fanboy...and damn proud of it!!
just installed the UR pulley 2 weeks ago.... id rate it as 3/10 only because I its a pain break the bolt loose...but other than that its pretty easy
It is about as hard as spelling the word "install" .................
