I just bought a 72mm performance throttle body and I will probably recieve it in a week or so, but I didn't think about the intake manifold. Does anyone know the diameter that the stock intake manifold (2.2 ecotec) can hold? And will I need a new one? And if I would need one, anyone know a site where I could get one?
Replies are appreciated a lot, thanks in advance.
http://www.cardomain.com/ride/2208703
that throttle body is too big and I doubt it will work on the eco
I was a retard, and now I'm permanently banned.
you don't need one if you aren't boosted
I was a retard, and now I'm permanently banned.
then sell it or send it back
I was a retard, and now I'm permanently banned.
dario osmanagich wrote:Yeah but I need to put on my new throttle body, I don't want it to just sit there and be a waste of $300.
Sent it back and get your money back.
MAN, you should have done some research before a newbie purchase like that.
http://members.rankmyride.com/djtorello
If they told you it will work on your car, then use this to tell them that you want your cash back, return this thing. On an N/A eco, I won't go over the 62mm, you can get one from RSM, OR, you get one from the junkyard and have a machine shop bore it to 62mm. This is what I'm gonna do when I'll have the cash and that I found a good machine shop. I think that the 71mm are used on drag car, since you car is barely stock.... I looked in your profile and.... please get rid of the "chip" in your engine mods, in your profile and in your car, there's no chip for the OBDII J-Body. If you want an advice, ask people here about things you may want to get, you'll have answers really quickly if it's junk and it will save you a lot of cash.
Good Luck!!!
