Ok keep in mind im removing the aftermarket crank pulley

tools you will need:
jack
tire iron or impact
small sockets for wheel well lining unsure of size i think 6.5mm
19 mm socket
21 mm socket
jackstand


first you get your car moved so you have space to work on it


next you jack up the passenger side front of the car. Jack stands are reccomended




Remove the wheel from the passenger side front


remove the wheel well lining or loosten up and bend out of the way. it will look something like this


loosten the bolt while the belt is still attached


remove the bolt it makes it easier to get to the tensioner

now remove the belt


pull the pulley off and replace with the new one


put the bolt back in and tighten it up


now put the belt back on



now reverse the steps and put it back together and then your done
and dont for get to put it back together right or you will have holes in your wheel well lining like this



also while doing this is a good time to let the dog out

Nice write up. It's not as hard as people think. But... why, may I ask, did you put the stock on back on?



2004 Cavalier
13.2@105........
Mods...
BFG Drag Radials
Saab Turbo kit
2.5 exhaust, w/cutout
Spec Stage 2+ Clutch

i sold the rk sport underdrive pulley im hoping to get a stock sized light weight one

first, those are the gayest rims I have ever seen! NEONS R GAY! Second, that is the coolest dog I have ever seen, I have had 3 of them. Had one that looked exactly like that, we had to put her on a diet cause she wouldn't stop eating and her belly dragged on the ground, cute as hell tho! Nothin like a fat Dachshund. Third, what size bolt is is on that crank pulley, you have two different sizes listed, whats up with that????




Scott

When I boost, you boost, we boost
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
You have been banned from NEJBODY.
You've displayed wayyy too many acts of pushing people to their limits.
It's never cool to tear people down for what they want to do.
NEJBODY is a team. We're not the same as JBO where everyone bashes on eachother.
I'm surprised you show up to our meets after half of the things you say on here.

Cheesecake wrote:i sold the rk sport underdrive pulley im hoping to get a stock sized light weight one

Soon my friend, soon.



PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO

-MD- LD9 wrote:

Cheesecake wrote:i sold the rk sport underdrive pulley im hoping to get a stock sized light weight one

Soon my friend, soon.

i hope so




and iif i remember correctly its the 19 mm