Alright so i bought a vaccum gauge to fill in an empty spot on my pillar. i went to hook up the hose that came with the kit and i cant find a vaccum big enough to fit the t fitting they gave me with the gauge. either their to small of a hose or their way to big like the brake booster. Is there any place on the engine were i can find an easy to get to vaccum hose to hook this up at?
dude, you need to do some searchign and reading and buy a haynes manual.....the all the questions you are asking are valid but we shouldnt spoon feed ya everything. /flame
most of the vacuum lines are small black tubes, check around the intake area.
My car may run 18s, but I can do your taxes in 10 seconds flat.
JBO lube - they would never have enough in stock and we'd never see RodimusPrime again
look around your intake manifold... look for thin black hose.....
|Forged 8.9:1 Wiseco Pistons|Forged Eagle Rods|HPTuners|60trim|Tial Wastegate|
|Precision Intercooler|2.5" Exhaust|2.5" Charge Pipes|630CC Mototron Injectors|
|Stock: Fuel Pump, Transmission, Manifold, TB, Head, Head Gasket, Ignition, Suspension...|
if it doesn't fit, there are these places called auto parts stores where you can buy fittings/tees/adapters to make it work
Edited 1 time(s). Last edited Friday, January 05, 2007 3:53 AM
Arrival Blue 04 LS Sport
Eco
Turbo
Megasquirt
'Nuff said
What i ended up doing for a good vac source for my turbo setup was, take the intake manifold off and drill a small hole in the mani. Than i just got a fitting that screwed into it with a hose fitting on the other side. Bu sure you seal it real well tho. Than just run a hose from that to your gauge!
