trust me guys, ive searched for this and even PM'd a few people but cant get a definitive answer.

ok, i picked up a Z-spec underdrive crank pulley and im gonna install it Thursday (I hope). but i was also going to delete the a/c system without the delete pulley (ive got a drop top...no reason to have an a/c when your whole cab can be open )

1. what belt would i use to run just the crank pulley?
2. what sized belt would i need to use if i used the crank pulley AND no a/c (without the delete pulley)?

edit: its for a 98 2.4l
any help would be great here guys.






Edited 1 time(s). Last edited Tuesday, December 05, 2006 9:25 AM


Check out my CARDOMAIN page

I really do not think you will get an answer. I have been told that a 345K5 will fit a stock 2.4 with a stock sized crank. I would start with that size and move down from there. That belt is used without a/c. But unless you can find a member that has a RSM pulley I'm not sure. I would talk to MASIN, I know he bought a RKSPORT crank pulley, my crank pulley, an unorthodox crank pulley, and a RSM crank pulley. He might have the belt size laying around somewhere.



PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO

thanks for the info. i was afraid i wouldnt be able to get a definitive answer. 345k5 is the belt that has come up the most, but again i didnt think it would be useful for no a/c AND an underdrive pulley.




Check out my CARDOMAIN page