So i just recently put it on my coils and the spark plugs and my car is mis firing like a b**** on startup... Any opinions on this?


http://www.cardomain.com/ride/2090440

Sounds like a loose or bad connection. Unless that is you used a packet of grease for each plug... The grease is non-conductive, so if your plug connectors were a little loose to begin with, they probably aren't making a full connection anymore. Pull them off and wipe the excess off around the contact area and try again. Remember to wipe it off inside the plug wire too (fun part).





4cyltuner.com - Information Source For 4 Cylinder Tuners
Buy stuff from CarCustoms Ebay! Won't be disappointed!

check to make sure some didnt get on the insulators



12.5@116 2.0 60ft

Thanks guys im going to check this crap out tomorrow. I havent even been able to drive it its so bad!!!!!!!!!!!!!!!


http://www.cardomain.com/ride/2090440