OK guys I am rebuilding a 99 2200 2.2L and I am wanting to darton sleeve it for a bigger bore and a more stable motor under boost. So anyways anyone have the block dimensions so i can send them to darton.
Lol, you're wasting your money. The block is plenty strong enough, and with boost you won't gain much by going more than 1mm over.
fortune cookie say: better a delay than a disaster
O I see, I am use to LS1's and honda engines.
also with sleeves you will loose some heat transfer properties how much boost are you wanting to run ... also dont forget that you have to make that head flow enough air so you dont have a super hot intake charge (and its hard make the ln2 head flow a lot of air)
