I'm looking to build an engine I have an 086 head. I need everything else from a 2.3 lower end/ timing chain area. etc etc.
Let me know what ya got and how much your looking to get for it.
We have a block, crank ,and a set of rods. The block is cleaned, magnafluxed-ok, and ready for bore, the cranks is standard, all it needs is a polish, and the rods would need to be brushed. As is before the machine work, we'll let it all go for $235. If you want me to give you a quote with machine work, call me at work tomorrow. , The machine shop I work at is in Woodville. My number is 715-698-2666.
Project Resurrection is in full swing!
Quote:
We have a block, crank ,and a set of rods. The block is cleaned, magnafluxed-ok, and ready for bore, the cranks is standard, all it needs is a polish, and the rods would need to be brushed. As is before the machine work, we'll let it all go for $235. If you want me to give you a quote with machine work, call me at work tomorrow. , The machine shop I work at is in Woodville. My number is 715-698-2666.
How much to have it bored and honed .40 (?)
could your machine shop knife edge the crank for me?
Quote:
o, who wants the first "KIT"
Oil pump _GM
Pump Pick Up_GM
Pick up brace_GM
Windage tray_GM
12 Inch pipe plugs
drill bit
tap
Instructions from BrianJBO
Price would be 550 shipped.
Chris
Chris
'02 Z-24 Supercharged
13.7 @102.45 MPH Third Place, 2007 GMSC Bash SOLD AS OF 01MAR08
oooh, ya this motor is gonna be nice!
who makes the best after market fuel injector? rc?
Maken Waves wrote:Quote:
We have a block, crank ,and a set of rods. The block is cleaned, magnafluxed-ok, and ready for bore, the cranks is standard, all it needs is a polish, and the rods would need to be brushed. As is before the machine work, we'll let it all go for $235. If you want me to give you a quote with machine work, call me at work tomorrow. , The machine shop I work at is in Woodville. My number is 715-698-2666.
How much to have it bored and honed .40 (?)
could your machine shop knife edge the crank for me?
$80 to bore the block and to knife edge the crank would be charged by the hour, $85 per hour, and no idea what it would take. But would need to be balanced afterwards, that's $125.
Project Resurrection is in full swing!
