hooked this thing up three times and all it shows is three bars across the screen. I don't know if there is some programming that needs to be done or if anyone can help me get this going on my boosted Z. Thanks for the help. I know Rodimus Prime has it as I seen in the dyno video. And I think Phil QBE has it too. Please help asap. Three bars supposedely means a power signal problem. but this I cannot figure out.


01 Z24 Turbo

read the instructions , you have to do some programing


plus i think the 3 bars was no comunication

LC-1 red wire to switched 12v
LC-1 blue wire to ground
LC-1 metallic wire to XD-1 ground
XD-1 red wire to switched 12v
LC-1 serial out to XD-1 serial in
LC-1 serial in ---> terminator plug

^ i have it wired right. I dont get how the programming works. Do I need a laptop in my car hooked up to my lm one software? Thanks for the help guys.


01 Z24 Turbo

you need to follow the instructions


i had me a bit puzzled also , but i finially got it working


how ive got no clue , but the instructions help

you need to follow the instructions


i had me a bit puzzled also , but i finially got it working


how ive got no clue , but the instructions help

im about to install my wideband XD1 just seeing how other people hooked there's up

mine is still sitting in the box . Could not get it working. I just gave up on it and since its winter I haven't tried again.


01 Z24 Turbo /// First Reflashed Turbo AUTO MMMM YUMMY

man that sucks if i get it working ill let you know how i did it

I know mine works fine, did you calibrate it? That's one of the first things you need to do ebfore it works right



LE61T PTE6262 Powered

don't you need a labtop to do that?