This is a single gauge steering wheel pod I made a while ago. Its painted with SEM texture coating to match the stock interior.





My plans changed and I decided to make a 3 gauge steering wheel pod. here is the process













Finished installed pictures








I still haven't figured out a way to wire in a hazard switch. I might just make an extension and apoxy it to the existing hazard switch and cut a hole in the pod out the left side.

Stock Stereo FTW! and is that NO dash crack I see?

But in all seriousness, looks clean. Like the look. Although 3 pods seem kinda clustered in that area, I enjoyed the look of the one pod

most of your pictures do not work.




On the inside my car looks like a fighter jet.

Andrew Cramer wrote:Stock Stereo FTW! and is that NO dash crack I see?

But in all seriousness, looks clean. Like the look. Although 3 pods seem kinda clustered in that area, I enjoyed the look of the one pod

shhhhhh - it might here you and crack.

I like the "Modified stock/could have came from factory look" which is kinda what im going for with my car. The gauges and the location function well. I tried out the gauges in the center vent thing, but found it distracting looking over at them.

As for the pictures-they work for me. I organized my photobucket after I made the post which is prob why.

Well its kinda pointless if the pix only work for you dont ya think???




Currently #4 in Ecotec Forced Induction horsepower ratings. 505.8 WHP 414WTQ!!!
Currently 3rd quickest Ecotec on the .org - 10.949 @ 131.50 MPH!!!

Lol, every time I look at this post a different set of 3 pictures work and the other 10 or so don't.




On the inside my car looks like a fighter jet.

Well I can assure you not having the pictures show up was not intentional.

when I revisited the thread a couple didn't show up for me this time.
lets try this again

good work bud

looks good, but I think 3 is too crowded. I made a single for my car and like it a lot. Next time I plan on making a dual pod for the cover.

Looks great.

Good work.

I don't like that the odometer is covered, but like the work and the paint used.



FU Tuning

Man that's awesome. I would love to have one of these. I agree three is a little crowded however it looks awesome. Personally I would love one with two of them and the with the center left open.

Bump

Parting out car, check Classifieds (Interior Forum) for sale details