Duramix 4040...is the only thing l could find through searching....
Looking for a how 2....
and if anyones knows of any different methods....?
are you asking how to mold them in or what?
Zspot Zedden wrote:Duramix 4040...is the only thing l could find through searching....
Looking for a how 2....
and if anyones knows of any different methods....?
Be more specific on what you are trying to do, and maybe you'll get a answer.
I will be tring to get them on the car.....
I was told that the y don't clip / screw on like the stock sides...
Just looking into what it takes to install them...?
^^^no rust problems...?^^^
check my cardomain page i have snaps of the side skirts
Link
Hey Bagged those look tight.....
If you have time please e-mail me a how too...
If mine turn out that good l would be sssoooo happy....
wzehr@city.waterloo.on.ca
screws go in fender wells, so even if they do rust it won't really matter. plus, you could fiberglass over the screws if you wanted.
i'm not sure how everyone else did it but that's what i've often heard.
So screw them up through the fender walls and double side tape down the center..?
just be careful if u decide to take them somewhere..the place that put mine on riveted an L bracket into my quarter panel..and now that i am taking the skirts off...i have to pay to get the hole welded shut and repaint the car....stupid f*ckers! here's what it looks like after getting cut off by an suv and bumping into a curb...u can c the L brcket:
Mold them on. Thats my suggestion. It gives it alot cleaner look on the sides however it is alot more work then just bolting them on.
btw, Baggedcav your car looks hot. Espically it slammed against the ground!~
<imghttp://memimage.cardomain.net/member_images/12/web/396000-396999/396307_34_full.jpg>
i will be molding them on next winter for now l just want a nice clean look to get me through this summer....oh ya and so they do,t fall / hang off....
